SolaWrap Greenhouse Installation Guide

**** Please note- The sample packet is free. The international postage will be additional.****

In order to have a good installation the following tips are recommended:

• Measure your bow spacings- the distance between the supports.
• You should be at 4,5,6 feet or 2 meter spacing.  If this is not the case please make adjustments to the bows or add additional perlins to make this possible. (Call us we are here to help and give you options).
• Unevenly spaced bows make your vertical installation difficult, but not impossible.  (Again just give us a ring).
• Measure your longest length run needed.  This is how much material will be required for your structure.  Please keep in mind that you can not successfully seam the material without loss of structural strength.
• Rolls are sold either in custom lengths or as master rolls, which are 328 feet in length. **Please note that the first wrap around the rolls is not part of this count, it is given as additional protection during shipping, if your first layer is damaged, not to worry!  It is not calculated in your material request.

• Install tracks into your frame with self-taping screws (stainless or galvanized is recommended) 1 ¼” to 1 1/2 “ in length. Insert the Solawrap film into the tracks.

***Optional for Warmer Climates:  It is suggested that a neoprene washer to added to the screw at the assembly to help spread the load and prevent the screw from heating up and melting through the extrusion. Screw spacing recommendation is 12” -24” apart depending on the wind, rain, and snow loads. For low snow load areas, 17” spacing is adequate.  In high wind and snow loads, 12” spacing is recommend.

Tracking must be aligned properly or film could get damaged when inserted.

After correct alignment is achieved, seal the joint with weather UV resistant silicone.

Where the film first enters the extrusion tracking, we recommend that the ends are terminated in a manner to round the sharp corners to prevent cutting as the material slides into place.

Tools and Equipment Needed For Solawrap Installation:

• Sharp cutter/blade
• Measuring tape
• Marker
• Self-taping screws (stainless or galvanized is recommended) 1 1/4-1 1/2“in length.  ***Optional for warmer climates it is suggested that a neoprene washer be added to the screw at assembly to help spread the load, and prevent the screw from heating up and melting through the extrusion.

• Ladders, and or scissor lifts
• Drill or impact driver with 5/16 bit, or one of your choosing
• Saw
• 2 work horses and a bar (at a minimum 1 foot longer than your film size.
• Clear silicone, outdoor and waterproof (used for the connections between your extrusions.
• Chanel lubricant, WD-40, soapy water etc
• 

Please visit our Facebook page for more pictures and videos.

Do you have a SolaWrap Greenhouse Installation questions?

By Phone Toll Free In the U.S.   866 597 9298

By Phone directly:   760 597 9298

By Fax:  760 597 9574